Стандартные программы Windows



         

Boot.ini - часть 5


Unlike the /crashdebug switch, /debug uses the COM port whether you are debugging or not. Use this switch when you are debugging problems that are regularly reproducible.

For additional information about remote debugging, click the following article number to view the article in the Microsoft Knowledge Base:

121543 Setting up for remote debugging

/debugport=comnumber

This switch specifies the communications port to use for the debug port, where number is the communications port, such as COM1, that you want to use. By default, /debugport uses COM2 if it exists. Otherwise, the switch uses COM1. If you include this switch in the Boot.ini file, the /debug switch becomes active.

For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

151981 How to set up a remote debug session using a null modem cable

/EXECUTE

This option disables no-execute protection. See the /NOEXECUTE switch for more information.

/fastdetect:comnumber

This switch turns off serial and bus mouse detection in the Ntdetect.com file for the specified port. Use this switch if you have a component other than a mouse that is attached to a serial port during the startup process. For example, type /fastdetect:comnumber, where number is the number of the serial port. Ports may be separated with commas to turn off more than one port. If you use /fastdetect, and you do not specify a communications port, serial mouse detection is turned off on all communications ports.

Note In earlier versions of Windows, including Windows NT 4.0, this switch was named /noserialmice.

For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

131976 How to disable detection of devices on serial ports

The reason the qualifier exists (vs. just having NTDETECT perform this operation by default) is so that NTDETECT can support booting Windows NT 4. Windows Plug and Play device drivers perform detection of parallel and serial devices, but Windows NT 4 expects NTDETECT to perform the detection.


Содержание  Назад  Вперед